The FLEC® has been validated and used in research for many years.
Below is a publication list of journal articles, abstracts, poster or oral presentations where the FLEC or CHEMATEC’s other products have been in focus.
If you have anything that can be added to the list, we encourage you to contact CHEMATEC.
2016 |
Liu, Xiaoyu; Allen, Matthew R; Roache, Nancy F Characterization of organophosphorus flame retardants’ sorption on building materials and consumer products Journal Article In: Atmospheric Environment, vol. 140, pp. 333 - 341, 2016, ISSN: 1352-2310. Abstract | Links | BibTeX | Tags: Material-air partition coefficient, Material-phase diffusion coefficient, Organophosphorus flame retardants, Sink, Sorption strength @article{LIU2016333,Better understanding the transport mechanisms of organophosphorus flame-retardants (OPFRs) in the residential environment is important to more accurately estimate their indoor exposure and develop risk management strategies that protect human health. This study describes an improved dual small chamber testing method to characterize the sorption of OPFRs on indoor building materials and consumer products. The OPFRs studied were tris(2-chloroethyl) phosphate (TCEP), tris(1-chloro-2-propyl) phosphate (TCIPP), and tris(1,3-dichloro-2-propyl) phosphate (TDCIPP). The test materials and products used as sinks include concrete, ceiling tile, vinyl flooring, carpet, latex painted gypsum wallboard, open cell polyurethane foam, mattress pad and liner, polyester clothing, cotton clothing, and uniform shirt. During the tests, the amount of OPFRs absorbed by the materials at different exposure times was determined simultaneously. OPFRs air concentrations at the inlet and inside the test chamber were monitored. The data were used to rank the sorption strength of the OPFRs on different materials. In general, building materials exhibited relatively stronger sorption strength than clothing textiles. The material-air partition and material phase diffusion coefficients were estimated by fitting a sink model to the sorption concentration data for twelve materials with three OPFRs. They are in the range of 2.72 × 105 to 3.99 × 108 (dimensionless) for the material-air partition coefficients and 1.13 × 10−14 to 5.83 × 10−9 (m2/h) for the material phase diffusion coefficients. |
1999 |
Meininghaus, Roman; Salthammer, Tunga; Knöppel, Helmut Interaction of volatile organic compounds with indoor materials—a small-scale screening method Journal Article In: Atmospheric Environment, vol. 33, no. 15, pp. 2395 - 2401, 1999, ISSN: 1352-2310. Abstract | Links | BibTeX | Tags: FLEC, Indoor air, Mass transport, Permeability, Sink @article{MEININGHAUS19992395,Indoor air pollution caused by volatile organic compounds (VOCs) may affect the health and well-being of inhabitants. Uptake and release of these compounds by and from indoor materials alter their concentrations in indoor air: uptake will lower peak concentrations, whereas subsequent (slow) release at lower concentration levels will prolong the presence of VOCs in indoor air. An experimental set-up has been implemented where indoor materials are placed as a “membrane” separating two air compartments. Both compartments – consisting of Field and Laboratory Emission Cells FLECs – are constantly flushed with air, one air stream containing a mixture of 20 VOCs, and concentrations in both compartments are measured after 1 h. Ten materials usually covering extensive surfaces indoors were consecutively exposed to the vapour mixture at concentration levels typically found in indoor environments. Under the chosen experimental conditions, five of these materials exhibited a permeability high enough that VOCs could be detected on the other side. Mass transport of VOCs into and through indoor materials has therefore been confirmed by experiment. The set-up allows for a quick screening of indoor materials with respect to their sorption capacity and permeability. |